How to Tie a Puffy Bow
Article by KarensVariety.com
 

Materials:

Length of ribbon for bow, any width Piece of small ribbon for centre Tape

Fold the piece of short ribbon once lengthwise and lay on table. Wind the long ribbon loosely around your hand to form a roll. Press the roll together in centre.
Fold at centre and cut two V shaped pieces out as shown. Tie the small piece of ribbon at the notch.
Pull out loops from the inside, alternating one to the left and then to the right. Give each loop a full twist to the centre after pulling out. Continue to pull out loops and arrange bow as desired. The finished bow is round, full and holds its shape. Bow is ready to tie on package. For a flat bow, use less ribbon and pull loops out sideways.